Руководство Toyota Corolla Repair Manual

Год издания: 2010
Страниц: 243
Язык: английский
Формат: PDF
Размер: 102 Мб
Руководство по устройству, эксплуатации, техническому обслуживанию и ремонту автомобилей Toyota Corolla 2003 – 2008 гг. выпуска оборудованных бензиновыми двигателями.

2409201522_56 

Отрывок:

15.14 Place the gasket over the dowels (lower arrows) on the engine block - when installing the oil pump, align the flats in the pump rotor with the flats on the crankshaft (upper arrows)

16.3 Mark the flywheel/driveplate and the crankshaft so they can be reassembled in the same relative positions

13 Place a new oil pump gasket on the engine block.

14 Position the pump assembly against the block and install the mounting bolts. Make sure that the flats on the oil pump drive rotor align with the flats on the crankshaft (see illustration).

15 Tighten the bolts to the torque listed in this Chapter's Specifications in three or four steps. Follow a criss-cross pattern to avoid warping the body.

16 Reinstall the remaining parts in the reverse order of removal 17 Add oil if necessary, start the engine and check for oil pressure and leaks. 16 Flywheel/driveplate - removal and installation Removal Refer to illustrations16.3 and 16.5 1 Raise the vehicle and support it securely on jackstands, then refer to Chapter 7 and remove the transaxle.

2 Remove the pressure plate and clutch disc (see Chapter 8) (manual transaxle equipped vehicles).

3 Use a center punch or paint to make alignment marks on the flywheel/driveplate and crankshaft to ensure correct alignment during reinstallation (see illustration).

4 Remove the bolts that secure the flywheel/driveplate to the crankshaft. If the crankshaft turns, have an assistant wedge a screwdriver in the ring gear teeth to jam the flywheel.

5 Remove the flywheel/driveplate from the crankshaft. Since the flywheel is fairly heavy, be sure to support it while removing the last bolt. Automatic transaxle equipped vehicles have spacers on both sides of the driveplate