Год выпуска 1968
Фориат PDF
2609201509_24
Отрывок из руководства по ремонту NISSAN DATSUN:
The engine is of monobloc construction, and the valve are set in line in the cylinder head and are operated by rockers and push rods from the camshaft in the left hand side of the engine.
The camshaft, running in three steel backed whitemetal bearings, is chain-driven and has a rubber chain tenssioner.
The distributor and oil pump are driven from the camshaft.
The pistons are the split skirt type of aluminum alloy, and carry two compression rings and a slotted oil control ring.
The piston pins are bolted in connecting rods, which have steel backed lead and copper alloy, changeable big end bearings.
A counter balanced crankshaft is fitted. The end thrust on this component is taken by special washers at the center main bearing. The centrifugal water pump and cooling fan are driven by the generator belt.
GENERAL SPECIFICATIONS
The camshaft, running in three steel backed whitemetal bearings, is chain-driven and has a rubber chain tenssioner.
The distributor and oil pump are driven from the camshaft.
The pistons are the split skirt type of aluminum alloy, and carry two compression rings and a slotted oil control ring.
The piston pins are bolted in connecting rods, which have steel backed lead and copper alloy, changeable big end bearings.
A counter balanced crankshaft is fitted. The end thrust on this component is taken by special washers at the center main bearing. The centrifugal water pump and cooling fan are driven by the generator belt.
GENERAL SPECIFICATIONS
